English
España
Deutsch
The use of CNC processing equipment for processing has high efficiency and good quality, but if the process design is not handled properly, it will directly affect the output and even affect the quality and other issues. Today I will share with you the technical problems:
1. The CNC machining process is too scattered
The reason for this problem lies in the fear of complexity (referring to the preparation time), simple programming, simplified operation and processing, easy adjustment of tool setting with one tool, and accustomed to ordinary processing. As a result, product quality (position tolerance) is not easy to guarantee, and production efficiency cannot be brought into full play. Therefore, CNC machining process personnel and operators should be fully familiar with CNC machining knowledge, try more to master relevant knowledge, and use process-intensive methods as much as possible for machining. If you use it several times, it will naturally reflect its advantages. After the use of process concentration, the unit processing time increases. We arrange the two equipment face to face, and realize that one person can operate the two equipment. The efficiency is greatly improved, and the quality is also very well guaranteed.
The reason for this problem lies in the fear of complexity (referring to the preparation time), simple programming, simplified operation and processing, easy adjustment of tool setting with one tool, and accustomed to ordinary processing. As a result, product quality (position tolerance) is not easy to guarantee, and production efficiency cannot be brought into full play. Therefore, CNC machining process personnel and operators should be fully familiar with CNC machining knowledge, try more to master relevant knowledge, and use process-intensive methods as much as possible for machining. If you use it several times, it will naturally reflect its advantages. After the use of process concentration, the unit processing time increases. We arrange the two equipment face to face, and realize that one person can operate the two equipment. The efficiency is greatly improved, and the quality is also very well guaranteed.
2. The CNC processing sequence is unreasonable
Some CNC machining operators consider some problems in preparation, and often arrange the machining sequence extremely unreasonably. Numerical control processing is usually processed according to the requirements of general mechanical processing technology, such as first coarse and then fine (tool change), first inside and then outside, reasonable selection of cutting parameters, etc., so that quality and efficiency can be improved.
Some CNC machining operators consider some problems in preparation, and often arrange the machining sequence extremely unreasonably. Numerical control processing is usually processed according to the requirements of general mechanical processing technology, such as first coarse and then fine (tool change), first inside and then outside, reasonable selection of cutting parameters, etc., so that quality and efficiency can be improved.
Use G00 (G26, G27, G29) fast positioning instructions with caution. The G00 instruction brings great convenience to programming and use. However, if the setting and use are improper, it will often result in undesirable consequences such as overshoot when returning to zero due to excessive speed setting, loss of accuracy, and strain on the guide rail surface of the equipment. If you don't pay attention to the return route, it is easy to cause safety accidents that collide with the workpiece and equipment. Therefore, when considering the use of the G00 command, you should consider it thoroughly and not arbitrarily.
In the numerical control processing, especially should pay attention to strengthen the retrieval and trial operation of the program. After the program is entered into the control system, the operator should use the SCH key and the ↑, ↓, ←, → movement keys to perform uncertain and definite retrieval, and modify the program if necessary to ensure the accuracy of the program. At the same time, before the formal execution of the program processing, the program must be tested (turn on the power amplifier) to confirm whether the processing route is consistent with the design route.
The above are some common problems and solutions when using CNC machining equipment. There may be other problems encountered in actual work, but as long as CNC machining technicians and operators think more about them, and earnestly master the knowledge and skills of CNC, CNC equipment can bring great benefits to the enterprise. .
